Adding Discov3ry Complete (UM2+ & Discov3ry) to Cura 4.1

These instructions will walk you through step by step how to add your Discov3ry Complete 3D printer (Ultimaker 2+ with Discvo3ry extruder) to Cura in just minutes. The setup will provide you with default printer, material, and slicing profiles in Cura to get you 3d printing any paste.

  1. Install Ultimaker Cura 4.1.

  2. Run Cura and choose Get started on the set up screen. Read and Agree to Ultimaker’s disclaimer. Review Whats New and choose Next. Review the data collection policy, choose Next.

  3. Click on the Add a non-networked printer drop down menu. Select Other, and choose Discov3ry Complete (Ultimaker 2+).

  4. Sign into Ultimaker Cloud if you choose, if not, click Finish.

  5. Boom, you’re done! You are now ready to load your STL.

Cura will then Load with the following default profiles:

  • Printer: Discov3ry Complete (Ultimaker 2+)

  • Material: DAP 100% Silicone

  • Print Core: 0.84mm (Green)

  • Print Settings: Extra Fast (0.3mm), 100% Infill, Skirt, 15mm/s, No Temp, 205mm^3 volume.