About the Ultimaker category


#1

This topic is to discuss all things Ultimaker, especially integration with the Discov3ry Paste Extruder. For installation instructions for the Ultimaker 2 see here.

For Discov3ry integrations, please ensure that you post to the correct thread for your printer. You can either edit the wiki if you have a tried and tested mod, or pose a comment/question/concern in this thread. If your printer is not yet listed, please create a new topic and we will set up a new wiki for you.

Ultimaker 2 Integration Wiki and Discussion Thread


#2

I was wondering if there is already a document on how to connect the Discov3ry Paste Extruder on an Ultimaker 3 (mainly for the g-code part). I’m trying it right now by using the information I found on this forum for the integration with an Ultimaker 2, but this is not working (yet).
Kind regards,
Fréderick Matheuse